Solutions
For organisations that rent many camera masts or are considering buying them. You buy the mast and place it yourself. We aim the cameras, arrange alarm response and take care of management. You have one point of contact and one monthly fee.
Does your organisation rent camera masts project after project, or are you considering buying them? With a mast of your own, you swap weekly rental for a lower monthly cost, but who handles the management? A mast only adds value if it is set up properly at every location, stays connected and forwards alarms reliably. That is what Cameramast Management takes care of.
You place and relocate the mast yourself. We take care of the rest: our specialists in the design and installation of VSS/CCTV aim the cameras, configure smart detection and test alarm forwarding at every deployment. After that, we continuously monitor power, connectivity, storage and cameras via TowerGuard, and we are your first point of contact in case of a fault. So you can be sure the mast works when it matters.
From advice to management
A solution that fits your location. From the first consultation to day-to-day management: we agree in advance what you can expect from us.
We discuss your site, activities and security requirements to determine which solution and services fit.
You receive a proposal covering the configuration, facilities and arrangements for placement, management and any alarm response.
We coordinate placement and commissioning with you. Before handover we check operation and the agreed integrations.
We provide the agreed technical management. In case of a fault we investigate the cause and agree the next steps.
Alarms are handled according to the chosen service and the arrangements for assessment and response.
Has your location or security need changed? We coordinate the adjustment and check operation again.
Configuration and services differ per client and are agreed in advance.
One point of contact
Univora Security coordinates the entire chain. Hardware, connectivity, camera settings and the link to the monitoring centre are covered by one management subscription. In case of a fault you call us, and we bring in the right party.
With every alarm, the monitoring centre sees the live video from the mast. It is immediately clear whether something is going on, and false alarms are filtered out.
The cameras detect crossing a virtual line and entering a zone. We set the zones and sensitivity per location, so wind, animals and shadows cause as few false alarms as possible.
Management is carried out by specialists with extensive experience in configuring camera masts. They are experts in the design and installation of VSS/CCTV systems, so you can always rely on professional knowledge.
Through TowerGuard, NXGEN's monitoring platform for mobile camera masts, we see the status of all your masts in one place. Power, connectivity, storage and the cameras are monitored continuously. If anything fails, we are alerted immediately and step in before it becomes a problem.
TowerGuard by
The mast is delivered in your own house style, with your colours and logo. That makes it not only security, but also good advertising for your organisation wherever it stands.
The mast stands on its own base and you move it yourself when your project moves. We then re-aim the cameras and check the detection zones.
A one-off purchase of your mast, followed by ongoing management and response.
You buy the mast and own it straight away.
One-off
Placing and relocating
One monthly fee per mast, one point of contact.
Per month
With every placement
Response of your choice
You receive a tailored quote based on the number of masts and the term. The monitoring centre is included in the monthly fee; mobile patrol is charged separately.
Renting or owning
Already renting camera masts regularly, or considering buying them? Then owning a mast with professional management pays off.
Indicative, based on continuous use compared with renting. We are happy to calculate it for your situation.
Wherever surveillance and lighting are needed temporarily or quickly.
Protection of equipment and materials, and work lighting in the dark months.
Storage, outdoor areas and fences that are unattended outside working hours.
Car parks, entrances and build-up areas, placed quickly and removed again.
Temporary surveillance of vacant buildings and sites in transition.
Mast, connectivity, cameras and monitoring centre link from one partner, for one monthly fee.
Specialists with extensive experience in camera masts and in the design and installation of VSS/CCTV.
Alarms handled by our monitoring centre, with live video, or by a mobile patrol on site.
A fixed rate per mast, so you can easily add masts as your locations grow.
Mains power required for continuous use. The mast runs on a 230 V connection. If the power fails, the battery takes over. Without lighting, cameras, recording and alarm transmission are expected to stay active for several hours; with both floodlights on, this is considerably shorter. We therefore advise switching the lighting off automatically during a power cut. Backup duration depends on the mast configuration and is agreed with you per project. Does the mast need to run fully stand-alone, without a mains connection? Ask us about the options, for example a larger battery or solar panels.
For organisations that already rent many camera masts, or are considering buying masts. Think of contractors, infrastructure companies and site managers with ongoing or recurring projects. The more often the masts are used, the faster an own mast pays for itself compared with renting.
A firm, level surface and a 230 V power connection. Connectivity runs through the 4G router in the mast, so no network cable or Wi-Fi is needed. We of course help you choose the right spot in advance, so the cameras have an optimal view of the site and 4G coverage is good. You place the mast yourself; after placement we check the connection and video remotely.
The built-in battery keeps cameras, recording and connectivity active for several hours, as long as the lighting is off. With both floodlights on, the battery drains much faster. If desired, the monitoring centre receives an alert on power failure, so action can be taken in time.
For each camera we set fixed positions with their own detection zones and alarm rules. From those positions the camera monitors the site. When an alarm occurs, the monitoring centre can pan and zoom the camera remotely to assess the situation.
You move the mast yourself. We then make sure the cameras are re-aimed and the detection zones checked, remotely where possible and on site otherwise. That is part of Cameramast Management, so surveillance stays reliable at the new location.
We use TowerGuard by NXGEN, a monitoring platform built specifically for mobile camera masts. It collects real-time data per mast on power, connectivity, storage and equipment status, and alerts us as soon as something deviates. That gives us all your masts in one overview, so we can resolve faults as early as possible.
Univora Security. We are the first technical point of contact, resolve what we can remotely and, for a hardware problem, bring in the supplier for repair or warranty.
On 1 TB of local storage in the mast itself. Through the management platform you can watch live and search recordings. The management subscription includes the required user licences.
We aim the cameras at your own site and keep public space and neighbours out of view as far as possible. Univora Risk & Security can help with the DPIA, signage and agreements on retention periods if needed.
Tell us where and for how long you want to use the masts. We are happy to think along with you, without obligation.
Contact us